Hobart

Module: HOB+0121 0GB

katherine

Module: HOB+0083 0GB

• approx 11:00 UT, antenna stuck. Resetting drives not working. Called Jamie who advised that it is likely due to weather. KE removed from dynamic observing at this stage. (JR)
• If it is not up and working by ~23:00 UT, will contact Mick Stone and see if it is possible for him to make a trip out. (JR)
• Attempted to contact Mick. Left a message. (JR)
• 23:30 UT. Spoke to Warren who suggested that Brett may know what Mick needs to do to reset the drives. Brett to get into contact with Mick (who is currently on site) (JT)
• 00:04 UT Issue resolved. Ke back is schedule. Fix: the power isolator to the antenna drives are located at knee height below the antenna drive cabinet in the pedestal. When the switch is vertical, the isolator is on. Mick switched it off momentarily (verified by 'it going quiet'), and then switched it back on. 10-20 seconds later HMI updated and the drives were OK again. Should you need to talk someone through this, get them to use the UTAS headset at yg (attached to x6283) (JR)
• 08:11 UT - “wth” command doesn't return any values, a search for “wx” revealed it hasn't been working for at least last 30 mins - told Jamie. (Ellen)
• 09:57 UT - Weather command now giving the 3 required values. Jamie fixed it? (Ellen)

Yg

Module: HOB+0069 0GB

• 00:45 UT alarm for no pcfs activity for 15 minutes. e-remote control lost connection and currently unable to vnc to pcfsyg (JR)
• 01:05 UT connection re-established, e-control back up and able to ping timeyg and pcfsyg - dyshed script had to be restarted (JR)
• 01:08 UT Back down again. (JR)
• 01:17 UT reset VPN, still unable to connect
• 01:30 UT rebooted D-Link router via vnc 59.167.111.242. dyshed script restarted again, appears to be working (JR)