This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
handover:ohg102 [2016/02/17 17:33] Jim Lovell |
handover:ohg102 [2016/02/18 10:14] (current) Jim Lovell |
||
---|---|---|---|
Line 4: | Line 4: | ||
Module:USN+0220, start pos: 2625.458 GB | Module:USN+0220, start pos: 2625.458 GB | ||
+ | |||
+ | 1800 UT - Experiment started ok. (Ellen) | ||
+ | * 0917 eremotecontrol retunred onsource as slewing twice before retuning tracking. This was followed with the following two errors (AK) | ||
+ | - error an -103 pointing computer tracking errors are too large. | ||
+ | - error qo -301 warning: onsource status is slewing! | ||
+ | * 0930 UT (approx) one of the Hobart s band sys temp spiked to about 3300 while another to about 1300, the relevant channel numbers were recorded in the checklist | ||
**Katherine** | **Katherine** | ||
Module: USN-0137, start pos: 1666.807 GB | Module: USN-0137, start pos: 1666.807 GB | ||
+ | |||
+ | 1800 UT - Experiment started ok. (Ellen) | ||
+ | |||
+ | * 0759 UT Katherine had the following error "error ib -4 gpib device time-out on response c2". Wiki had instructions on "ERROR sp -4 GPIB Device time-out on response c2". As per the wiki's suggestion, ran the "counter" command followed by the input of "maserdelay" and "clkoff" a few times. Everything seems okay (AK) | ||
**Yarragadee** | **Yarragadee** | ||
Line 13: | Line 23: | ||
Module: USN-0150, start pos: 2296.388 GB | Module: USN-0150, start pos: 2296.388 GB | ||
+ | 1800 UT - Experiment started ok. (Ellen) | ||
+ | * Call station at the end of the experiment to change modules. (AK) | ||
{{tag>}} | {{tag>}} | ||
~~DISCUSSION~~ | ~~DISCUSSION~~ | ||
- |