User Tools

Site Tools


This wiki is not maintained! Do not use this when setting up AuScope experiments!



Module:USN+0220, start pos: 2625.458 GB

1800 UT - Experiment started ok. (Ellen)

  • 0917 eremotecontrol retunred onsource as slewing twice before retuning tracking. This was followed with the following two errors (AK)
    1. error an -103 pointing computer tracking errors are too large.
    2. error qo -301 warning: onsource status is slewing!
  • 0930 UT (approx) one of the Hobart s band sys temp spiked to about 3300 while another to about 1300, the relevant channel numbers were recorded in the checklist


Module: USN-0137, start pos: 1666.807 GB

1800 UT - Experiment started ok. (Ellen)

  • 0759 UT Katherine had the following error “error ib -4 gpib device time-out on response c2”. Wiki had instructions on “ERROR sp -4 GPIB Device time-out on response c2”. As per the wiki's suggestion, ran the “counter” command followed by the input of “maserdelay” and “clkoff” a few times. Everything seems okay (AK)


Module: USN-0150, start pos: 2296.388 GB

1800 UT - Experiment started ok. (Ellen)

  • Call station at the end of the experiment to change modules. (AK)
You could leave a comment if you were logged in.
/home/www/auscope/opswiki/data/pages/handover/ohg102.txt · Last modified: 2016/02/18 10:14 by Jim Lovell