User Tools
Sidebar
hardware:phasecal
This wiki is not maintained! Do not use this when setting up AuScope experiments!
This is an old revision of the document!
Monitoring Phase Cal tones
Recording one scan with Phase Cal ON for 19 minutes using vgos_recorder.py. Followed by another scan of just a couple of minutes with Phase Cal off for comparison. Inifile configured as:
# Do a test to record Phase Cal ON at different Frequencies
[DBBC3]
dBBC3Address = 131.217.63.227
dBBC3Port = 4000
Station = Hb
LOfreq = [3500, 3000, 4500]
NumberOfChannels = [8, 8, 8, 8, 8, 8]
CutOffFreqA = [3200.0,3600.0,4000.0,4400.0,4800.0,5200.0,5600.0,6000.0]
CutOffFreqB = [3200.0,3600.0,4000.0,4400.0,4800.0,5200.0,5600.0,6000.0]
CutOffFreqC = [6400.0,6800.0,7200.0,7600.0,8000.0,8400.0,8800.0,9200.0]
CutOffFreqD = [6400.0,6800.0,7200.0,7600.0,8000.0,8400.0,8800.0,9200.0]
CutOffFreqE = [9600.0,10000.0,10400.0,10800.0,11200.0,11600.0,12000.0,12400.0]
CutOffFreqF = [9600.0,10000.0,10400.0,10800.0,11200.0,11600.0,12000.0,12400.0]
Data recorded in Flexbuff Hb
mkdir /mnt/vbsPcal/
vbs_fs -n 4 -I *pcal_*2205 /mnt/vbsPcal/
ls -l /mnt/vbsPcal/
/home/www/auscope/opswiki/data/attic/hardware/phasecal.1558505674.txt.gz · Last modified: 2019/05/22 06:14 by Guifre
