This wiki is not maintained! Do not use this when setting up AuScope experiments!

This is an old revision of the document!

Chair/Presenting: Ellen/

In Attendance:

Apologies: Jonny, Ross, Arwin

Absent:

___

Agenda:

General Issues

• Caltsys at Ho not set during startup means overflowing (useless) tsys values. DO THE CHECKLIST PROPERLY.
• Does Arwin's windstow script work?
• Is the new flogit script working now? Before it was giving log file .prc extension
• Warren sent out an email re module allocation - check spreadsheet during experiment set up (rapids shouldn't go on modules with anything else, except each other)

http://auscope.phys.utas.edu.au/opswiki/doku.php?id=operations:log

• Make sure you check the end of experiment email before sending it - especially how much data is on each module if multiple are used, this should be recorded in the handover notes when the banks swap over

Issues from Handover notes

• AUA013 - during setsup ifc power levels were below target, 27K when expecting 32k (Arwin?)