User Tools

Site Tools


operations:agenda2020_09_24

This wiki is not maintained! Do not use this when setting up AuScope experiments!

This is an old revision of the document!


Table of Contents

Chair: Earl

Next meeting chair: Jay

Attended:

Apologies:

General Issues

Handover Issues

AOV051

Hobart 12m

  • Autocorrelations have been funky, suspect file has been messed with? Ignored for now (Eloise/Warren)

AUM019

Yarragadee 12m

  1. 1820 to 1831 UT, received a consistent warning trak waiting at limit. No scan affected (mas)

Hobart 12m

  1. 2240 UT No data being recorded. Restart jive5ab seems to have fixed issue (Warren)
  2. 2250 UT Guifre also to check J2Start ??? (w)
  3. 2256 UT First recordings (w)

si0265

Hobart 12m

  • 1530UT - Experiment started ok (Prad)
  • DBus error pops up at intervals. IF source not defined for detector device?
  • proc file error - missing the edited preob/postob that would have recorded the X-band data. Only S-band recorded to module, no useful data recorded. (JMc)
  • NB - Use aumm5bhb.prc as the proc file!

ohg127

Hobart 26m

  • Issues with very large clkoff measurement, auto correlations, configuring dbbc. Have restarted / rebooted DBBC, mark5, hobart etc. Warren will look at it in the morning.
  • 0537 - Experiment resumed after dealing with multiple issues. DBBC was in unusable state, apparently due to a fault in the 10 MHz reference cable. Also investigated RF/IF system following up on recentr non-detections. Found a failed cable compensator which has been bypassed. (JMc)
  • Ongoing issue - No valid Tsys readings. Origin unclear. (JMc)
/home/www/auscope/opswiki/data/attic/operations/agenda2020_09_24.1600915958.txt.gz · Last modified: 2020/09/24 02:52 by Earl Lester