User Tools

Site Tools


operations:temphumidmonitor_hardware

This wiki is not maintained! Do not use this when setting up AuScope experiments!

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
operations:temphumidmonitor_hardware [2019/03/26 01:36]
Jim Lovell [Connections for the DHT22 sensors]
operations:temphumidmonitor_hardware [2019/04/03 23:22] (current)
Jim Lovell [Connections for the DHT22 sensors to the RJ45 bus]
Line 71: Line 71:
 The DHT22 has 4 pins but pin 3 is not used.  The DHT22 has 4 pins but pin 3 is not used. 
  
-{{ :​hardware:​dht22-pinout.png?​direct |DHT22 pinout}}+{{ :​hardware:​dht22-pinout.png?​direct%300 |DHT22 pinout}}
  
 Each one requires a connection to power and ground plus a unique GPIO port on the Raspberry Pi for data. The RJ45/CAT5 has 8 wires. Two are reserved for power and earth so that leaves 6 for sensors. The RJ45 terminal blocks have a different wire colouring to the CAT5 cable. Here's how they are allocated: Each one requires a connection to power and ground plus a unique GPIO port on the Raspberry Pi for data. The RJ45/CAT5 has 8 wires. Two are reserved for power and earth so that leaves 6 for sensors. The RJ45 terminal blocks have a different wire colouring to the CAT5 cable. Here's how they are allocated:
  
 +^ RJ45 Pin number ^ CAT5 wire colour ^ RJ45 terminal block wire colour ^ GPIO# or power assignment ^ ID on unit ^ 
 +| 1 | orange/​white | grey    | 4 | TH1 | 
 +| 2 | orange ​      | orange ​ | 17 | TH2 | 
 +| 3 | green/​white ​ | black   | 18 | TH3 | 
 +| 4 | blue         | red     | +3.3V | 
 +| 5 | blue/​white ​  | green   | GND | 
 +| 6 | green        | yellow ​ | 27 | TH4 | 
 +| 7 | brown/​white ​ | blue    | 22 | TH5 | 
 +| 8 | brown        | brown   | 23 | TH6 |
/home/www/auscope/opswiki/data/attic/operations/temphumidmonitor_hardware.1553564210.txt.gz · Last modified: 2019/03/26 01:36 by Jim Lovell