Software installed on windows PC (ops1) in control room

• From the Resource DVD:
  • PC200W
  • RTMC web server (started installing after PC200W automatically!)
  • SCWin (aka Short Cut)
  • Device Configuration Utility
  • SMS (Storage module software)
  • RTMC Pro 4.0 Trial
  • RTMC Web Server 3.2 Trial (not sure if this was already done or not)
  • RTDAQ 1.0 Trial (selected trial when asked for serial number)
  • PCTDR 2.07
• From the LoggerNet CD
  • Installed the software (key printed on CD)

• Ran LoggerNet and started through setup wizard
  • Selected CR1000, named it Array 1
  • Selected IP Port as Communication Setup
  • Now need to give it an IP address…
    • Will configure over serial connection
    • USB to serial connector required driver from manufacturer:
      • Manual at at http://sabrent.com/product-manuals/USB-TO-SERIAL-CABLES_Manual.pdf
      • Want driver for SBT-USC6K from http://www.sabrent.com/downloads.php
      • Followed installation instructions
      • Came up on COM3, 9600 baud, 8 bit, parity none, stop bits 1, flow control none.
    • Connected power to logger via DC power-pack. No luck. Direct connection to battery works
    • MAC address for Array 1 00d02c04b057, Array 2 00d02c04b051 and temporary IP addresses are 131.217.62.92 and .93 respectively and called AUScope-Array1.phys… and AUScope-Array2.phys…
    • In Device Config Utility,
      • Connection over serial with ethernet plugged in, shown DHCP working and TCP port set to 6785
      • In Datalogger tab, Station name is Array1, PakBus Address 1, security code 0
      • edited .cipasswd file (New Services Tab) to give usual observer password for admin, FTP password for anonymous is the same
      • In logger Control, hit Set clock (synchs with PC clock, so that needs to be on an NTP server)
      • In data monitor, can see logged data (after plugging in sensors), other stats like batther level etc.
      • Finished, so disconnect.
    • Now in EZSetup Wizzard
      • IP address set to 131.217.62.92:6785, pakbus 1, security code 0
      • Comm test worked!
    • Configured Array2 as above, just different name and I address, PakBus Address 1 (tried 2 but failed the comms test).