skip to content
AuScope VLBI Operations Wiki
User Tools
Log In
Site Tools
Search
Tools
Show pagesource
Old revisions
Backlinks
Recent Changes
Media Manager
Sitemap
Log In
>
Recent Changes
Media Manager
Sitemap
You are here:
start
»
deformation
»
testsetup1
Trace:
•
testsetup1
Sidebar
Home
Operations
Contact information
schedules
Documentation for operators
Handover notes
Current Issues
Meetings
Archive
Technical
deformation:testsetup1
This wiki is not maintained! Do not use this when setting up AuScope experiments!
This is an old revision of the document!
Notes on Test Setup in AuScope Control Room
PC Software
Software installed on windows PC (ops1) in control room
From the Resource DVD:
PC200W
RTMC web server (started installing after PC200W automatically!)
SCWin (aka Short Cut)
Device Configuration Utility
SMS (Storage module software)
RTMC Pro 4.0 Trial
RTMC Web Server 3.2 Trial (not sure if this was already done or not)
RTDAQ 1.0 Trial (selected trial when asked for serial number)
PCTDR 2.07
From the LoggerNet CD
Installed the software (key printed on CD)
Ran LoggerNet and started through setup wizard
Selected CR1000, named it Array 1
Selected IP Port as Communication Setup
Now need to give it an IP address…
Will configure over serial connection
USB to serial connector required driver from manufacturer:
Manual at at
http://sabrent.com/product-manuals/USB-TO-SERIAL-CABLES_Manual.pdf
Want driver for SBT-USC6K from
http://www.sabrent.com/downloads.php
Followed installation instructions
Came up on COM3, 9600 baud, 8 bit, parity none, stop bits 1, flow control none.
Connected power to logger via DC power-pack. No luck. Direct connection to battery works
MAC address for Array 1 00d02c04b057
/home/www/auscope/opswiki/data/attic/deformation/testsetup1.1346215738.txt.gz
· Last modified: 2012/08/29 04:48 by
Jim Lovell
Page Tools
Show pagesource
Old revisions
Backlinks
Back to top