User Tools

Site Tools


handover:crf98

This wiki is not maintained! Do not use this when setting up AuScope experiments!

CRF98

Hobart

Disk VSN: HART-032

Volume at Beginning: 0GB

  • 17:30UT Experiment started OK (Ross)

Katherine

Disk VSN: IPA-0028

Volume at Beginning: 0GB

  • 17:30UT Experiment started OK (Ross)

Yarragadee

Disk VSN: BKG-0037

Volume at Beginning: 0GB

  • 17:30UT Experiment started OK (Ross)
  • 16:00UT Lost connection to yarragadee, network problem. Yg VPN needed a reset. (Arwin)

Hobart 26

disk HOB+0025

  • 03:00 UT Just found out that Ho should also be observing. Apparently Warren did start it, though this was missed by AuScope observer. The schedule started late (6 hours late) due to changeover from astronomy schedule confusion. First full scan is 019-0017 at 00:17 UT. Additional problems due to wrong recorder specified in the schedule. Experiments seems to run fine, will send off start message now. (Lucia)
  • 03:50UT Vacuum pressure is at 3.9 (should be <3.5). Told Brett and he will take care of it. (Lucia)
  • 05:42UT Vacuum pressure was low (3.5) now is 3.9 again. Spoke to Brett. As long as the temperature (70k) is not rising, we are good. 70k stage has been stable at about 54K over the last two hours. (Lucia)
  • 15:00UT Have been getting the following errors: “ ERROR ib -4 GPIB Device time-out on response ca” and “ERROR qy -1 Error in response from counter”. Consulted with Warren, he said not to worry about these. (Arwin)
You could leave a comment if you were logged in.
/home/www/auscope/opswiki/data/pages/handover/crf98.txt · Last modified: 2017/01/19 17:06 by Jesse Swan