This wiki is not maintained! Do not use this when setting up AuScope experiments!
This is an old revision of the document!
r4782
Hobart
Disk VSN: HOB+0055
Data Volume at Beginning: 6352.932 GB
Not enough volume remaining on HOB+0055 for this experiment - there will need to be an additional module put into the mk5 before experiment end
1830 UT Experiment started OK (Bryn)
New module is loaded in the other bank, should spill over once full.
Katherine
Disk VSN: WSRT-049
Data Volume at Beginning: 0GB
1830 UT Experiment started OK (Bryn)
Yarragadee
Disk VSN: HOB+0044
Data Volume at Beginning: 0GB
1830 UT Experiment started OK (Bryn)
0230 UT yg network was all clogged up. The webacam was hogging all the bandwidth, needed a reset. This was causing problem with the ntpq server getting its time properly which caused a higher than normal offset in the mk5=dot?. The schedule was halted between 2017.069.02:16:17 to 2017.069.03:03:49. Scans missed were 069-0216b to 069-0308b (not inclusive of the last one). If you run comments.py, it should pick this up automatically.
You could leave a comment if you were logged in.
/home/www/auscope/opswiki/data/attic/handover/r4782.1489115979.txt.gz · Last modified: 2017/03/10 03:19 by Warren Hankey