User Tools

Site Tools


handover:r4782

This wiki is not maintained! Do not use this when setting up AuScope experiments!

This is an old revision of the document!


r4782

Hobart

Disk VSN: HOB+0055

Data Volume at Beginning: 6352.932 GB

  • Not enough volume remaining on HOB+0055 for this experiment - there will need to be an additional module put into the mk5 before experiment end
  • 1830 UT Experiment started OK (Bryn)
  • New module is loaded in the other bank, should spill over once full.

Katherine

Disk VSN: WSRT-049

Data Volume at Beginning: 0GB

  • 1830 UT Experiment started OK (Bryn)
  • 0435 UT Telescope had a few issues with the drives here. I got it going once with the antenna=operate and antenna=open. However I dont think it went to source until scan 069-0509. It wasnt ringing an alarm the second time but the log said “antenna stuck”. Pretty much all data starting 04:35 to 05:00 is invalid. First cab should be 069-0509. (Arwin)

Yarragadee

Disk VSN: HOB+0044

Data Volume at Beginning: 0GB

  • 1830 UT Experiment started OK (Bryn)
  • 0230 UT yg network was all clogged up. The webacam was hogging all the bandwidth, needed a reset. This was causing problem with the ntpq server getting its time properly which caused a higher than normal offset in the mk5=dot?. The schedule was halted between 2017.069.02:16:17 to 2017.069.03:03:49. Scans missed were 069-0216b to 069-0308b (not inclusive of the last one). If you run comments.py, it should pick this up automatically. (Arwin)
You could leave a comment if you were logged in.
/home/www/auscope/opswiki/data/attic/handover/r4782.1489122422.txt.gz · Last modified: 2017/03/10 05:07 by Warren Hankey