This wiki is not maintained! Do not use this when setting up AuScope experiments!
This is an old revision of the document!
Chair/Presenting: Ellen/
In Attendance:
Apologies: Jonny, Ross, Arwin
Absent:
___
Agenda:
General Issues
Caltsys at Ho not set during startup means overflowing (useless) tsys values. DO THE CHECKLIST PROPERLY.
Does Arwin's windstow script work?
Is the new flogit script working now? Before it was giving log file .prc extension
Warren sent out an email re module allocation - check spreadsheet during experiment set up (rapids shouldn't go on modules with anything else, except each other)
Make sure you check the end of experiment email before sending it - especially how much data is on each module if multiple are used, this should be recorded in the handover notes when the banks swap over
Issues from Handover notes
AUA013 - during setsup ifc power levels were below target, 27K when expecting 32k (Arwin?)
/home/www/auscope/opswiki/data/attic/operations/agenda2016_10_13.1476312351.txt.gz · Last modified: 2016/10/12 22:45 by Ellen Manning