This wiki is not maintained! Do not use this when setting up AuScope experiments!

This is an old revision of the document!

Chair: Jay

Next meeting chair:

Attended:

Apologies:

General Issues

• Hb dbbc3 samplers values were bad for couple of aua/aum experiments

Handover Issues

aum029:

• one flexbuffhb system disk still down guifre and warren working on rebuild
• mk5yg reboot sometime around 1900 UT

aua074:

• flexbuffhb file sytem errors /dev/sdq1 machine making alarm noises, reconfigure dbbc again.one system disk down, disk13. repaired it on flexbuffhb, make space(w)
• illegal state error for KE - antenna=open etc - warren fixed it

AUM028:

KE:

• TCP/IP connection closed” multiple times (Lim)
• No recordings after power interruption(?) and network error. preob procedure did not include the “runtime” command, leading to incompatible format issues. No alarms raised by log monitor, though error was active (JMc)
• received a continuous error “ Error st -999 tcp/ip connection was closed by remote peer”. Had tried to reboot the drive, but the antenna still failed and stuck till the end of the experiment (1800 UT) (mas)

AUM027:

KE:

• no s band recorded before this time (wiki needs updating with new setup script), halted for reconfiguration of dbbc3ke (Lim)

YG:

• edited setupsx in procedure file, had been copied from aum018 (as per wiki) with wrong mode. Had inherited 16 channel from previous r1? Changed to 32. (warren)