This wiki is not maintained! Do not use this when setting up AuScope experiments!

Hobart shipping paperwork, part 1

Remove module from the Mark5B recorder and put a red sticker over the green dot. The sticker will (should) be on the workbench under the whiteboard.
Go to the printer in the office and put a sheet of sticky labels into the printer's tray (printable side down, and make sure it's the correct size with 7 rows and 2 columns) and note the row and column of the label to be printed to (Counting from the top left of the sheet as you look at it in the tray).
On pcfshb, run
```
cd /usr2/log
drudg <log file> all <x> <y>
```
where x and y are the row and column index of the label to be printed. for example:
```
drudg r4457hb.log all 2 3
```
Collect the printed label and put it on the front of the module where it says “Library Label”
Check the destination of the experiment using the IVS master list.
From the metal filing cabinet in the office, from the drawer marked NGS ENCODERS CEDUNA TIMING take:
- a DHL airways form,
- a plastic dhl envelope,
- address label for the destination correlator and
- an experiment label sticker .
- Fill out the DHL address following the examples below. Make a note of the billing number on the printed log sheets. %width=900px% http://www-ra.phys.utas.edu.au/~jmccallu/Washington.jpg“Washington” %width=900px% http://www-ra.phys.utas.edu.au/~jmccallu/Bonn.jpg“Bonn”