This wiki is not maintained! Do not use this when setting up AuScope experiments!

This is an old revision of the document!

Chair: Lim

next week's chair: Simin

Attended: Lucas, Katie, Prad, Jay, Mas, Earl, Simin, Eloise, Becca, Jamie, Ross

Apologies: Tiege, Patrick

Absent:

General Issues

• Yarragadee
  • VNC connection to maseryg?
    • Accessible through vnc maseryg:2
• Mixed-mode training?

Handover Issues

• CRD105
  • Hobart26m
    • FS locked up while investigating GPIB comms issue. PCFS machine rebooted (JMc).
    • Cleared afetr reboot
• AOV044
  • Hobart26m
    • 1954UT fs crashed
      • No apparent reason?
    • 2120UT Power failure led to DrivePC failure
    • Error: Cannot get monitor info from antenna (8020003); #antcn#Network I/O Timeout occurred on write
      • Need to restart DrivePc (sys26m)
    • 0812UT Power failure again
      • The RA/Dec/time values which were static earlier, now started changing after restarting DrivePC
    • 0910UT - Drives weren't ready on time for the last few scans. “drvon” on vdesk a few times seemed to have done the trick. Left drive (on) delay causing the problem? (Prad)
    • DrivePc or fs has to be restarted
    • Really need to “drvon” quite a lot on vdesk

Note: Don't rely on first start for the 26m Hobart, don't start only 5 minutes earlier.