This wiki is not maintained! Do not use this when setting up AuScope experiments!
This is an old revision of the document!
Katherine To Do
Phase cal testing (temperature stabilisation? Bad filters?)
DBBC service - check cables, internal connections, bad boards)
* Apparently working as of 25/7/14 after replacing Fila OUT, reseating stack & PCI7200 card & cables.
* earthing of DBBC and MK5 units using proper earth connections
* DBBC cont cal - tune for ~2-5% CONT CAL, 5-10% pulsed CAL
* CONT CAL seems to be triggered when PULSED CAL is? Check wiring on spare board?
* Y-factor tests - get all CAL factors via DBBC.
* <del>control room temp sensors - MoniCA
* twister cable suspender
* <del>fix UPS
pedestal and maser room fan, fix/replace
Upgrade mk5-2ke. Replace module back plane
* <del>Back up all PCs
* <del>Maser service.