This is an old revision of the document!
Check the Status Monitor to see if the Cross-over switches and RCP IF Attenuators are at the default levels:
The main thing is that the target power levels, once DBBC is set up and levels reported by fs command iread here are OK! If values aren't as above but power levels are attained without radical attenuation, then all is well.
Check the crossover switch and attenuator settings via the System Monitor GUI. If they are not correct, they can be adjusted using the rfpic
and ifpic
commands in the Field System. Documentation for these commands is here:
but each station has setup procedures for the default settings. Cross-over switched to Direct:
xodirect
IF attenuation to nominal:
ifnom